e1 is not responding

Unanswered Question
Aug 4th, 2007


I have MWR1941 router . This router has VWIC-2MFT-E1DIR. It has a default y cable configuration. My problem is associated with e1 . MY card is not sending any singnal. Please advise.Pls check the sh controller and sh run

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
royalblues Sun, 08/05/2007 - 00:04

The controller shows loss of frame.

Make sure the framing matches at both ends. Try chnaging it to framing no-CRC4 under the controller confguration and test


Paolo Bevilacqua Sun, 08/05/2007 - 00:31

There are also loopbacks on the line and because this appears to be a professional installation for mobile neetwork, you probably have a maintenance department that should look into that.

royalblues Sun, 08/05/2007 - 08:13

Still loss of frame.

also saw alarm incoming signal as well. You need to check the parameters at both ends


bikash_bd Mon, 08/06/2007 - 20:07

Dear Narayan,

I have solved the problem yesterday night and sorry inform you. I had to reconfigure it.



This Discussion