08-04-2007 11:03 PM - edited 03-03-2019 06:11 PM
Dear,
I have MWR1941 router . This router has VWIC-2MFT-E1DIR. It has a default y cable configuration. My problem is associated with e1 . MY card is not sending any singnal. Please advise.Pls check the sh controller and sh run
08-05-2007 12:04 AM
The controller shows loss of frame.
Make sure the framing matches at both ends. Try chnaging it to framing no-CRC4 under the controller confguration and test
Narayan
08-05-2007 12:31 AM
There are also loopbacks on the line and because this appears to be a professional installation for mobile neetwork, you probably have a maintenance department that should look into that.
08-05-2007 07:02 AM
08-05-2007 08:13 AM
Still loss of frame.
also saw alarm incoming signal as well. You need to check the parameters at both ends
Narayan
08-06-2007 08:07 PM
Dear Narayan,
I have solved the problem yesterday night and sorry inform you. I had to reconfigure it.
Bikash
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide