Access list.

Unanswered Question
Aug 5th, 2007
User Badges:

I am trying to configure ACL for remote location, accessing one of application on specific port. At remote side they have created a VLAN (e.g. 11.1.x.x) and at main office inside VLAN is 11.2.x.x. I have added route(ip of remote router) to pix and applied this ACL to the outside interface. But the remote user is unable to access application.

For example:

access-list inside_acl 11.1.0.0 255.255.255.0 host 11.2.0.1 eq 23678

where,

11.1.0.0=> remote network

11.2.0.1=> server/host at main office


I am confused whether to apply this acl to Inside interface or Outside interface.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Sun, 08/05/2007 - 10:59
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


You need to apply this on the outside interface of your pix in the inbound direction as the user is in the remote office and is sending traffic to your vlan.


Be aware that there is an implict deny at the end of each access-list so if you apply that access-list as is it will only allow port 23768 from vlan 11.1.x.x through.


HTH


Jon

purohit_810 Sun, 08/05/2007 - 11:01
User Badges:
  • Silver, 250 points or more

Create it as a Extended permit, it should work.


access-list 100 extended permit tcp 172.16.1.0 255.255.255.0 10.1.1.0

255.255.255.0 eq 2000


and put it as on interface as a Outbound.


Regards,

Dharmesh Purohit

Actions

This Discussion