I have a cisco 2610 router, IOS version 11.3(8)T1. Though i have logging configured, the router does not show any log messages and i am not sure what the problem is. Plz find below the config that i have.
logging buffered 16384 debugging
logging trap notifications
logging facility local6
logging source-interface Loopback10
The lo10 is assigned with proper ip address and its status is up.
When i issue a "show log" command, below is the output
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Console logging: level debugging, 63 messages logged
Monitor logging: level debugging, 0 messages logged
Trap logging: level notifications, 21 message lines logged
Logging to x.x.x.x, 21 message lines logged
Buffer logging: level debugging, 63 messages logged
Log Buffer (16384 bytes):
Though the above output says that 63 messages logged, i dont see even a singloe message in the output. Any help in this regards is highly appreciated.