2950 Cisco Catalyst Switch

Answered Question
Aug 6th, 2007

Was wondering if a Catlayst 2950 can SPAN the G0/1 and G0/2 ports as well as all the 10/100 Ethernet Ports.

Shaun

I have this problem too.
0 votes
Correct Answer by Jagdeep Gambhir about 9 years 4 months ago

Yes, you can use it, that should not be a problem.

Regards,

~JG

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jagdeep Gambhir Mon, 08/06/2007 - 05:13

Shun,

You can have only one destination port.

?The destination port cannot be a source port; a source port cannot be a destination port.

?You can have only one destination port.

?For SPAN source ports, you can monitor sent and received traffic for a single port or for a series or range of ports.

It can have only one active SPAN or RSPAN source (rx, tx, both).

Hope that helps

Regards,

~JG

ShaunieK226 Mon, 08/06/2007 - 05:35

Thanks, Yeah I am aware that I can only have 1 session with a 2950 Series Switch. I just needed confirmation that I can use the Gibabics ports as source ports. I will be using E1/1 for my Snort box/destination port.

Thanks

Shaun

Actions

This Discussion