08-06-2007 05:01 AM - edited 03-05-2019 05:43 PM
Was wondering if a Catlayst 2950 can SPAN the G0/1 and G0/2 ports as well as all the 10/100 Ethernet Ports.
Shaun
Solved! Go to Solution.
08-06-2007 05:38 AM
08-06-2007 05:13 AM
Shun,
You can have only one destination port.
?The destination port cannot be a source port; a source port cannot be a destination port.
?You can have only one destination port.
?For SPAN source ports, you can monitor sent and received traffic for a single port or for a series or range of ports.
It can have only one active SPAN or RSPAN source (rx, tx, both).
Hope that helps
Regards,
~JG
08-06-2007 05:35 AM
Thanks, Yeah I am aware that I can only have 1 session with a 2950 Series Switch. I just needed confirmation that I can use the Gibabics ports as source ports. I will be using E1/1 for my Snort box/destination port.
Thanks
Shaun
08-06-2007 05:38 AM
Yes, you can use it, that should not be a problem.
Regards,
~JG
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: