cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
906
Views
10
Helpful
3
Replies

What command does RME issue on device(s) to backup configs

getwithrob
Level 3
Level 3

Telnet is the protocol used. What command or commands does RME use to backup device configs?

1 Accepted Solution

Accepted Solutions

The output from the device is captured into an accumulator buffer by the sync archive process, then written out to a temp file. That file is then moved into the archive location, and the database is updated.

View solution in original post

3 Replies 3

Joe Clarke
Cisco Employee
Cisco Employee

Assuming an IOS router device:

terminal length 0

terminal width 0

show privilege

terminal no monitor

enable

show running-config brief

show running-config

show startup-config

Note: not all commands will be used on all versions of IOS or all router device types.

I don't understand how the output is captured from the show running and show startup commands then saved in a file(s) on the RME servers.

The output from the device is captured into an accumulator buffer by the sync archive process, then written out to a temp file. That file is then moved into the archive location, and the database is updated.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: