DHCP excluded addresses

Answered Question
Aug 7th, 2007
User Badges:

I configured the Router to a specific DHCP pool . I put also the default gateway, name server etc. After that i configured to exclude some specific range of addresses. But when i write show dhcp ip pool ... i can not see the excluded addresses. How can i find them . Do i have to remember them or write them down.

Thanks

Moses.

Correct Answer by Richard Burts about 9 years 9 months ago

Moses


If you do show run you should see the excluded addresses as part of the running configuration. You could also do show run | include excluded


HTH


Rick

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Richard Burts Tue, 08/07/2007 - 07:15
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Moses


If you do show run you should see the excluded addresses as part of the running configuration. You could also do show run | include excluded


HTH


Rick

ankbhasi Tue, 08/07/2007 - 07:17
User Badges:
  • Cisco Employee,

Hi Moses,


You can see them in your running config.

"sh run | in exclude"


HTH


Ankur

sundar.palaniappan Tue, 08/07/2007 - 07:35
User Badges:
  • Green, 3000 points or more

Moses,


Both Rick and Ankur have provided the info to find the dhcp excluded address from the config.


To answer your specific question as to why the excluded address info doesn't show up with the 'show dhcp ip pool' command is because all the other values like network, default router, dns etc are configured under the dhcp pool mode whereas the excluded address is configured under the global config mode.


HTH


Sundar

Actions

This Discussion