cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
518
Views
0
Helpful
6
Replies

WCS is not seeing any AP's but see's the 4400

wallyabrams
Level 1
Level 1

I have WCS, A 4400 and 1130ag access points. WCS see's the 4400 but none of the ap's

1 Accepted Solution

Accepted Solutions

Hmmm... Are these APs running in lwapp or autonomous mode? They need to be in lwapp (lightweight) mode in order to be controlled by the controller

View solution in original post

6 Replies 6

ericgarnel
Level 7
Level 7

Does the 4400 see the APs?

Only with the cisco discovery service. I can ping them.

Hmmm... Are these APs running in lwapp or autonomous mode? They need to be in lwapp (lightweight) mode in order to be controlled by the controller

The rep sent the wrong AP's had to exchange 120 autonomous for LWAPP

Thanks

fynskisb16
Level 1
Level 1

I've seen the same problem. I've had to refresh the configuration from the controller to my WCS server. After doing that I was able to see all my AP's.

Thanks, but the rep sent the wrong AP

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: