Rob Huffman Wed, 08/08/2007 - 04:40
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Alan,

Here you go;

This example shows how to blink the access point LEDs for 30 seconds:

AP# led flash 30

This example shows how to stop the blinking of the access point LEDs:

AP# led flash disable

This example shows how to display the LED flashing status:

AP# show led flash

From this good doc;

Hope this helps!



This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode