Where is the RSSI info between 1500 AP's?

Unanswered Question
Aug 7th, 2007

Just wondering where in the WLC you can determine the signal strength between 2 1500's?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ctermini Wed, 08/15/2007 - 13:16

Hi,

On the wireless controller the following command will show Snr-Up, Snr-Down and aggregate Link-Snr.

(Cisco Controller) >show mesh path

rgds

Carlo

dancampb Fri, 08/17/2007 - 18:24

A good way to determine how well the 1500's are seeing each other is with the remote AP debugs. These will show you the SNR for an AP that is or isn't joined to the controller yet which is good in troubleshooting why a MAP won't join.

The commands to run them are:

debug ap enable

debug ap command dumpAdjs()

mathewvdh Tue, 08/21/2007 - 22:47

Whats classed as a good link SNR as far as the cisco 1500's are concerned? don't you need a RSSI value and a Noise value to determine SNR?

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode