08-07-2007 10:47 PM - edited 07-03-2021 02:27 PM
Just wondering where in the WLC you can determine the signal strength between 2 1500's?
08-13-2007 01:18 PM
RSSI should be -74 dbm between neighboring devices.
08-15-2007 01:16 PM
Hi,
On the wireless controller the following command will show Snr-Up, Snr-Down and aggregate Link-Snr.
(Cisco Controller) >show mesh path
rgds
Carlo
08-17-2007 06:24 PM
A good way to determine how well the 1500's are seeing each other is with the remote AP debugs. These will show you the SNR for an AP that is or isn't joined to the controller yet which is good in troubleshooting why a MAP won't join.
The commands to run them are:
debug ap enable
debug ap command dumpAdjs()
08-21-2007 10:47 PM
Whats classed as a good link SNR as far as the cisco 1500's are concerned? don't you need a RSSI value and a Noise value to determine SNR?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: