SHOW CONNECTIONS ON IOS

Unanswered Question
Aug 8th, 2007

Hi, is there a command to show active connections that pass through 2 eth ports on cisco ios?

Thx.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
graemeporter Wed, 08/08/2007 - 03:13

Hi there,

You could try:

show ip cache flow

See if that does what you need.

Kind regards,

Graeme

Pavel Bykov Wed, 08/08/2007 - 03:39

Also you could try enable accounting on the interface. It will not always display active connections since it's incremental (old connection stay in the list) but it can display what is flowing.

commands are:

(config-if)#ip accounting

#show ip accounting

#clear ip accounting (reset list)

Actions

This Discussion