08-08-2007 02:07 AM - edited 03-18-2019 07:40 PM
CME 4.1
Cisco 2851
c2800nm-ipvoicek9-mz.124-15.T1.bin
7961 and 7911
firmware: sccp.8-2-2SR1
30 channel PRI E1
When a call is received and connected from a mobile or landline, the display shows a random collection of characters below which is the calling number in brackets.
I have tried a number of different CLID suppression commands and isdn commands which have not worked.
When I downgraded to CME 4.0(2) c2800nm-ipvoicek9-mz.124-11.T2.bin, the display showed just the calling number, which is preferable.
08-14-2007 06:42 AM
upgrade the ios to latest one IOS 12.4(15)T1 and check it if ti solves the issue
08-14-2007 07:01 AM
Already running 12.4(15)T1.
08-16-2007 07:27 AM
Hi,
I also have the same issue with the garbage characters on the display when an incomming PSTN call is connected. Did you manage to find a fix?
I changed phones firmware with no luck. I did however remove my voice translation rule which was adding a '90' to the calling party number on the PRI. Once this was removed the issue cleared, but meant we lost the 90.
Thanks,
Chris
08-16-2007 07:35 AM
Yes, but my solution involved taking out the trunkgroup commands from the incoming dial-peer.
below is what I mean if you have not used it before.
controller E1 0/0/0
pri-group timeslots 1-31
trunk-group 1 timeslots 1-31 preference 1
dial-peer voice 1 pots
trunkgroup 1
incoming called-number .
So I just took out the trunkgroup 1 command and replaced it with port 0/0/0:15.
I am also translating the incoming called number and then applying to the voice-port 0/0/0:15:
voice translation-rule 1
rule 1 /^.*/ /9\0/ type national national
rule 2 /^.*/ /900\0/ type international international.
Dan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide