IOS command Line to show Associations

Unanswered Question
Aug 8th, 2007
User Badges:

I am looking for the IOS command that shows what users laptops are using a 1240. On the web interface under asscoiation tab it shows the device type, name ip address. Is there one for IOS commmand line?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Rob Huffman Wed, 08/08/2007 - 05:29
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Lawrence,

Use the show dot11 associations privileged EXEC command to display the radio association table, radio association statistics, or to selectively display association information about all repeaters, all clients, a specific client, or basic service clients.

show dot11 associations

[client | repeater | statistics | H.H.H | bss-only | all-client | cckm-statistics]


(Option) Displays all client devices associated with the access point


(Option) Displays all repeater devices associated with the access point


(Option) Displays access point association statistics for the radio interface

H.H.H (mac-address)

(Option) Displays details about the client device with the specified MAC address (in xxxx.xxxx.xxxx format)


(Option) Displays only the basic service set clients that are directly associated with the access point


(Option) Displays the status of all clients associated with the access point


(Option) Displays fast, secure roaming (CCKM) latency statistics measured at the access point for client devices using CCKM

From this doc;

Hope this helps!


lfranchini1 Wed, 08/08/2007 - 05:36
User Badges:

Thanks but I know and tried that command.

It is not showing the users that use the AP.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode