08-08-2007 09:30 AM - edited 03-14-2019 10:59 PM
I'm recieving an error on the voice translation ruleset and inbound calls are no longer translating. deb voice translation shows the following:
"Translation ruleset with tag-10 doesn't exist"
I can see the call hitting the appropriate dial-peer. The relevant configuration is thus:
voice translation-profile 8611
translate called 10
!
translation-rule 10
Rule 1 8611 4300
!
dial-peer voice 8000 voip
translation-profile outgoing 8611
preference 2
destination-pattern 8611
progress_ind setup enable 3
voice-class codec 1
session target ipv4:10.10.10.10
dtmf-relay h245-alphanumeric
no vad
!
Full Details of the debug:
.Aug 8 12:07:39 cdt: regxrule_profile_translate: number=5551212 type=national plan=isdn numbertype=calling
.Aug 8 12:07:39 cdt: regxrule_get_RegXrule: Invalid translation ruleset tag=0
.Aug 8 12:07:39 cdt: regxrule_profile_match: Error: ruleset for calling number not found
.Aug 8 12:07:39 cdt: regxrule_profile_translate: No match: number=5551212 type=national plan=isdn
.Aug 8 12:07:39 cdt: regxrule_profile_translate: number=8611 type=unknown plan=unknown numbertype=called
.Aug 8 12:07:39 cdt: regxrule_get_RegXrule: Translation ruleset with tag=10 doesn't exist
.Aug 8 12:07:39 cdt: regxrule_profile_match: Error: ruleset for called number not found
.Aug 8 12:07:39 cdt: regxrule_profile_translate: No match: number=8611 type=unknown plan=unknown
.Aug 8 12:07:39 cdt: regxrule_profile_translate: number= type=UNKNOWN plan=UNKNOWN numbertype=redirect-called
.Aug 8 12:07:39 cdt: regxrule_get_RegXrule: Invalid translation ruleset tag=0
.Aug 8 12:07:39 cdt: regxrule_profile_match: Error: ruleset for redirect-called number not found
.Aug 8 12:07:39 cdt: regxrule_profile_translate: No match: number= type=UNKNOWN plan=UNKNOWN
.Aug 8 12:07:39 cdt: regxrule_dp_translate: calling_number=5551212 calling_octet=0x21
called_number=8611 called_octet=0x80
redirect_number= redirect_type=4294967295 redirect_plan=4294967295
Solved! Go to Solution.
08-08-2007 03:17 PM
Hi,
try to configure:
voice translation-rule 10
rule 1 /8611/ /4300/
And should work.
Hope this helps, please rate post if it does!
08-08-2007 03:17 PM
Hi,
try to configure:
voice translation-rule 10
rule 1 /8611/ /4300/
And should work.
Hope this helps, please rate post if it does!
08-13-2007 09:10 AM
Switching to voice translation-rule resolved this issue. Thanks!
Any idea why the translation-rules would suddenly no longer work (perhaps IOS was upgraded unbeknownst...)?
08-13-2007 09:36 AM
No idea about the old translation commands, never used them.
Thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: