Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
190
Views
0
Helpful
1
Replies

SW & IPS Problem

tareqrebhi
Level 1
Level 1

‎08-09-2007 12:08 AM - edited ‎03-03-2019 06:14 PM

Dear I need to run my IPS i configured my sitch 3560 but when i entered this command :

monitor session 1 destination interface Fa0/24i lost the connection with IPS.

i put the monitoring IPS port at SW port/24 ....

what is the problem?

Labels:
0 Helpful
1 Reply 1

Pavel Bykov
Level 5
Level 5

‎08-09-2007 12:10 AM

Whenever port is destination of a span port it enters a monitoring state. This port receives a copy of all packets that are traveling through SOURCE ports/vlans.

This is standard function.

You have to communicate with your IPS some other way, if it's a span destination.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card