cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
645
Views
0
Helpful
3
Replies

QOS on 3560

cisco_lad2004
Level 5
Level 5

Hi all

I have VLAN based policy as per below.

sh mls qos inte XX stati shows correct marking, however show policy map vlan does not show any traffic clocking up.

I have applied similar strategy on 7600 and can see traffic rate on policy map.

mls qos

!

access-list 101 permit ip any any

!

class-map match-all MNGT

match access-group 108

!

policy-map 671-man

class vlan104

set dscp cs3

!

interface Vlan2990

service-policy input MVB-MNGT

!

interface GigabitEthernet0/2

mls qos vlan-based

no cdp enable

1 Accepted Solution

Accepted Solutions

wochanda
Level 4
Level 4

This is a limitation with the hardware on the 3560/3750 platforms. At this time we wont show # of policy-map matches in 'show policy-map interface'.

I dont believe there is a plan to fix this, so the best idea is using the 'show mls qos interface statistics' to make sure the policy is working.

View solution in original post

3 Replies 3

Pavel Bykov
Level 5
Level 5

please post more of the config. You have ACL 101, that is not refered to in any displayed class-map.

Also you have class vlan104 but there is no "class-map vlan104" configuration.

There is class-map MNGT configuration, but no policy-map refers to it.

Also, MNGT class-map refers to ACL 108, that is not displayed in config.

apologies, I quickly coped and pasted to highlight the method used and I can conform my marking is working as it should.

here is the correct conf:

mls qos

!

access-list 108 permit ip any any

!

class-map match-all MNGT

match access-group 108

policy-map MVB-MNGT

class MNGT

set dscp cs6

!

interface GigabitEthernet0/1

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1520-1526,2990

switchport mode trunk

mls qos vlan-based

!

!

interface Vlan2990

service-policy input MVB-MNGT

wochanda
Level 4
Level 4

This is a limitation with the hardware on the 3560/3750 platforms. At this time we wont show # of policy-map matches in 'show policy-map interface'.

I dont believe there is a plan to fix this, so the best idea is using the 'show mls qos interface statistics' to make sure the policy is working.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card