hi all,
I have a 6509 running SUP1A\MFC2 & Access Switches 3548XL
I am look to enable QoS on specific ports on these switches.
For the 6509
I have a trust setup below on the uplinks
set qos acl ip acl_1 trust-dscp ip 172.x.0.0 0.0.255.255 172.x.0.0 0.0.255.255 dscp-field 46
I have a 10/100 blade. Is it possible to configure these ports as trusted ports?
For the 3548
Which is the better cmd to use
switchport priority extend cos 5 switchport priority extend trust
Is there any further cmd that I need on the 3548 to enable QoS?
Thanks in advance