Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
228
Views
0
Helpful
1
Replies

IPS & SW Problem

tareqrebhi
Level 1
Level 1

‎08-09-2007 06:54 AM - edited ‎03-03-2019 06:15 PM

Dear

I need to run my IPS through network i configured my sitch 3560 but when i entered this command :

monitor session 1 destination interface Fa0/24

i lost the connection with IPS.i put the monitoring IPS port at SW port/24 ....

what is the problem?

Labels:
0 Helpful
1 Reply 1

anandramapathy
Level 3
Level 3

‎08-09-2007 08:28 AM

you should enable incoming & outgoing traffic on this interface which is in the monitor command. Else it will only capture packets from the switch

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card