cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
365
Views
0
Helpful
2
Replies

Reset cf:1 on IDS module sent SUP720 into ROMMON

hoffa2000
Level 3
Level 3

Greetings

I had a really weird and worrying problem today. In preperation to reimage an IDSM2 module in a Catalyst 6500 with SUP720 and IOS 12.2(18)SXF3 I sent the "hw-module module 5 reset cf:1" command in a telnet session to the switch.

This caused the switch to drop from the network and when I was able to set up a serial connection to the switch I found the SUP720 had rebooted into ROMMON.

The SUP720 is in slot 7 and the IDS in slot 5. Neither buffer log or syslog show any indication of what happened and I'm positive I sent the correct command.

Any ideas?

2 Replies 2

wochanda
Level 4
Level 4

Do a 'dir bootflash:' and see if this left a crashinfo file. If so, open a TAC case and let us decode it.

Hi

Thanks for the answer. Actually the Catalyst wrote a crashinfo. It confirms me sending reset module 5. I'll try to start a TAC right away. However the TAC seems to be broken at the moment.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: