cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
296
Views
0
Helpful
1
Replies

erase flash

balajee
Level 1
Level 1

Hi,

I have typed 'erase flash' command by mistake in my catalyst 2950 switch. After reboot, it stopped at "switch:" prompt. How to recover from here?. Where do I get IOS if I need to re-install? I am new to cisco products.

Thanks,

Balajee

1 Reply 1

spremkumar
Level 9
Level 9

hi

if you dont hve the backup of the ios installed in your switch you need to download the same from CCO with valid cco login credentials with additional privileges attached to which will allow you to do so.

But are you sure about the backup copy of ios ?

for recovery procedure you can refer this link..

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

regds

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: