Cisco 2811 w/ NM-ESW-16 Config for VLAN & WAN comms?

Unanswered Question
Aug 11th, 2007

Anyone seen config assistance docs for back-to-back Cisco 2811's (simulated WAN w/ cross-over cable attached to Fa0/1) when using the network modules' access ports on each router, on common VLAN, to communicate across the WAN? (Cisco's one config example for NM-ESW-16 doesn't explain how to config for egressing to a WAN for comms w/ a similar router/NM-ESW hardware combination.) Thanks, in advance.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Sat, 08/11/2007 - 15:13

What is exactly that you want to simulate ? There is nothing special in the module, imagine that the VLAN router interfaces are connecting to a switch that you also configure under their respective interfaces.

Then it depends what do you mean by WAN connections, as thereare of various types.

Actions

This Discussion