Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
795
Views
0
Helpful
1
Replies

Cisco 2811 w/ NM-ESW-16 Config for VLAN & WAN comms?

neill.clark
Level 1
Level 1

‎08-11-2007 02:45 PM - last edited on ‎03-25-2019 03:15 PM by Community Manager

Anyone seen config assistance docs for back-to-back Cisco 2811's (simulated WAN w/ cross-over cable attached to Fa0/1) when using the network modules' access ports on each router, on common VLAN, to communicate across the WAN? (Cisco's one config example for NM-ESW-16 doesn't explain how to config for egressing to a WAN for comms w/ a similar router/NM-ESW hardware combination.) Thanks, in advance.

Labels:
0 Helpful
1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

‎08-11-2007 03:13 PM

What is exactly that you want to simulate ? There is nothing special in the module, imagine that the VLAN router interfaces are connecting to a switch that you also configure under their respective interfaces.

Then it depends what do you mean by WAN connections, as thereare of various types.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card