Seed Device Limit in Campus Manager (LMS 2.6)

Answered Question
Aug 12th, 2007

Is there a maximum limit to the number of entries that can be added to the seed device file for device discovery in Campus Manager 4.0.9?

Ideally, I'd like to use the seed file from my NMS so that I have defined most of the devices to discover but it also gives scope to discover any that may have been missed - if I proceed with this, I'd be using a seed device file of 1064 devices.

Or does that sound a little too adventurous?

I'm upgrading from LMS 2.2 to 2.6 on new hardware and would prefer to re-discover the devices rather than a straight out import from the old system.

Thanks for any replies

I have this problem too.
0 votes
Correct Answer by frankzehrer about 9 years 3 months ago

Hi Claire,

maybe this link and the following five answers from jossy and questions from mermel

helps to clarify some things.

;-)

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.1dda9020/91#selected_message

Best regards,

Frank

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
cbajelis Sun, 08/12/2007 - 22:03

Hi Frank,

Thanks for your reply.

Great link, not only did it answer my question but jossy's explanation clarified things further.

I had searched earlier but didn't see that thread.

cheers,

Claire

Actions

This Discussion