08-13-2007 06:50 PM - edited 03-05-2019 05:52 PM
I connect a 3548-XL to a 2924-XL by 4 interfaces, I put all of them in trunking mode and I enter the following command on all of them:
SW(config-if)#port group 1
but the atherchannel dosn't be established.
08-13-2007 06:58 PM
have you looked at this document?
08-13-2007 07:59 PM
Thnak you for the link.
It is between a 6500 and 3548.
Is it possible that etherchannel dose not work between 3548-XL and 2924-XL?
08-13-2007 11:02 PM
I read the link,
One side in this document is 6500, there is command for "interface Port-channel1", I donot have this in running config of 3548.
My switches are 3548-XL and 2924-XL.
I configured all 8 interfaces with these commands:
#duplex full
#speed 100
#port group 1 distribution destination
#switchport trunk encapsulation dot1q
#switchport mode trunk
Only one port each side is in connected state.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: