08-14-2007 03:05 AM - edited 03-05-2019 05:53 PM
Any ideas on the following:- I have Cisco 3548XL and a Cisco 2960G, I am trying to link the both with a WS-G5483 GBIC Module. The 2960G picks it up no problem and the led indicate so. The 3548XL shows the module in the graphical interface and in show interface it also seeing the correct media type ( media type T) but interface is down/down, also there is no LED activity on the 3548XL. The 3548XL is runing IOS 12.0(5.3)WC1.
Hope some one can help?
Solved! Go to Solution.
08-14-2007 06:16 AM
Hi Friend,
You need at least 12.0(5)WC3b to support WS-G5483 on XL switch. Try to upgrade the switch and I believe it should work.
HTH
Ankur
*Pls rate all helpfull post
08-14-2007 06:16 AM
Hi Friend,
You need at least 12.0(5)WC3b to support WS-G5483 on XL switch. Try to upgrade the switch and I believe it should work.
HTH
Ankur
*Pls rate all helpfull post
08-28-2007 06:04 AM
Hi Ankur
Thanks for your help. Where can i get a history of the IOS release to know which is higher? I have the following versions but not sure which is best:-
(C3500XL-C3H2S-M), Version 12.0(5)XU, RELEASE SOFTWARE (fc1) :c3500XL-c3h2s-mz-120.5-XU.bin"
(C3500xl-C3H2S-M), Version 12.0(5)WC5, RELEASE SOFTWARE (fc1) :c3500xl-c3h2s-mz.120-5.WC5.bin"
(C3500XL-C3H2S-M), Version 12.0(5.2)XU, MAINTENANCE INTERIM SOFTWARE :c3500XL-c3h2s-mz-120.5.2-XU.bin"
Any Ideas would be much appreciated.
regards
Gordon
08-28-2007 06:20 AM
this one should work
(C3500xl-C3H2S-M), Version 12.0(5)WC5, RELEASE SOFTWARE (fc1) :c3500xl-c3h2s-mz.120-5.WC5.bin"
08-28-2007 06:22 AM
Thanks very much for your help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: