Moving D channel to channel 0 when configuring NFAS

Unanswered Question
Aug 14th, 2007
User Badges:

A colleague of mine (honestly :) is configuring a router with 5 T1 PRI's. The provider is working with him to configure NFAS so he can utilize the remaining D channels on the other T1's for B channel functions.


The problem he is running into, is that the Carrier setup the signaling on DS0 of the first T1.


Is there a way to change the signalling channel to not use channel 24?


He's already read this site:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_configuration_guide_chapter09186a008020ecee.html



Thanks,


-Scott

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Tue, 08/14/2007 - 18:45
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

No way, actually he should also ask to have a backup of the D channel on another circuit.


In any case if he still in time to rethink about the whole issue he should consider regular pri instead as a gain of 3 channels over 115 is not worth the added complexity in most cases.

Actions

This Discussion