IPS and Switch problem

Unanswered Question
Aug 16th, 2007

Dears,

i need to use commands:

monitor session 1 source interface Fa0/1 - 23

and

monitor session 1 destination interface Fa0/24

but when i put the second command i lost the connection with IPS sensor......what is the problem?

thank you.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pciaccio Thu, 08/16/2007 - 04:14

By making your port a SPAN port to in essence mirror all traffic to the destination port from your source port(s). You cannot interact on the destination port. I mean that the destination port does not function as an access port anymore until you remove the SPAN from it. You need to find an alternate path to your IPS. Either from the outside or console....

Actions

This Discussion