08-16-2007 08:37 AM - edited 03-05-2019 05:56 PM
I have a 2924M-XL switch that i erased the flash memeory on. How can I get it back on there so I can configure the switch?
08-16-2007 08:50 AM
when you say erased flash you probably erased everything including the image code.
you need to get the code and upload it back into the switch in order to bring it up for configuration.
do you see an rommon> promtp?
08-16-2007 08:50 AM
If your switch is not in the Rommon, then you can load an IOS image back to the switch with the following command
copy tftp: flash:
and change the boot path with the help of
boot system flash:
If the switch is in Rommon mode then you have to do a disaster recovery.
http://www.cisco.com/en/US/products/hw/switches/ps607/products_tech_note09186a0080094955.shtml
HTH
Narayan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide