outbound caller id on CME 4.1

Answered Question
Aug 16th, 2007
User Badges:

How can I get the full 10-digit originating number to show up during outbound calls? Right now, the dialed number on PSTN side gets the 4-digit extension.


This should be an easy one -- I've done this many times on CCM, 1st on CCME.



Thanks,

Jad

Correct Answer by paolo bevilacqua about 9 years 10 months ago

There is more than one way. One is "dialplan-pattern 1 555123.... extension-length 4"


Hope this helps, please rate post if it does!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
paolo bevilacqua Thu, 08/16/2007 - 13:54
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

There is more than one way. One is "dialplan-pattern 1 555123.... extension-length 4"


Hope this helps, please rate post if it does!

paolo bevilacqua Thu, 08/16/2007 - 14:16
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Great. For your information, you're one of the few users in the world allowed to send arbitrary numbers as caller-id. Use that wisely and don't pretend to be someone else, like the White House calling :)


Thanks for the nice rating and good luck!

jelzein Thu, 08/16/2007 - 15:49
User Badges:

Nice to know :)


I ran into another problem - once I added the dialplan, calls stopped forwarding to voicemail after 3 rings...it would just go to busy. Removing it fixed the problem, but now i'm back to square one. How can I get both to play nice together?

paolo bevilacqua Fri, 08/17/2007 - 02:57
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

The thing is likely now, calls going to VM are sent with the full calling number too.


Check debug ccsip message to confirm.


I think something can be done in the VM to accept these numbers as alias of the extension only, if not, there is a simple translation rule you can use instead


voice translation-profile make10

translate calling 10


voice translation-rule 10

rule 1 // /555123/


voice port x/y:23

translation-profile outgoing make10

jelzein Fri, 08/17/2007 - 07:07
User Badges:

Thanks again! That translation rule did the job just fine. I wasn't sure about the VM aliases, so didn't mess with that.


Jad

paolo bevilacqua Fri, 08/17/2007 - 08:43
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You are very welcome. Now the next part is when your customer will ask that certain extension present DID, others present pilot, and others again present "private" :)


Worry not we'll be here to answer that as well.

Actions

This Discussion