sh vlan bri

Unanswered Question
Aug 17th, 2007
User Badges:

Hi,

I have one cisco catalyst 2950 switch. Even after adding some ports in vlans, output of the command "sh vlan bri" not showing these ports in the corresponding vlans. Rest of the ports are shown properly. This is happening for few ports only.What could be the cause for this?


Thanks,

balajee

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Fri, 08/17/2007 - 00:44
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi Balajee


Could you send a copy of your 2950 config please.


Jon

Actions

This Discussion