Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
501
Views
0
Helpful
1
Replies

sh vlan bri

balajee
Level 1
Level 1

‎08-17-2007 12:38 AM - edited ‎03-05-2019 05:57 PM

Hi,

I have one cisco catalyst 2950 switch. Even after adding some ports in vlans, output of the command "sh vlan bri" not showing these ports in the corresponding vlans. Rest of the ports are shown properly. This is happening for few ports only.What could be the cause for this?

Thanks,

balajee

Labels:
0 Helpful
1 Reply 1

Jon Marshall
Hall of Fame
Hall of Fame

‎08-17-2007 12:44 AM

Hi Balajee

Could you send a copy of your 2950 config please.

Jon

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card