I have 2 WAN Connections.
1=Broadband connection with static IP (172.23.14.2)
2=T-1 connection with static IP (172.23.14.1)
I want all traffic to default to the Broadband connection (172.23.14.2) but I need a few IPs to route over to the T-1. The IPs I need to route to the T-1 are...
How & where to I enter this information? I only have the GUI interface to work with.
In the PDM I have the following setup and it is not working...
Under the Configuration - Host/Networks tab I've added an Outside Interface named Blah with the following specs.
IP = 126.96.36.199
Mask = 255.255.255.255
Int = outside
Name = Blah
Checked Define Static Route
Gateway IP = 172.23.14.1
Metric = 2
I have the same setup for the other 2 IPs as well(with different names). I've applied the command and saved the router config and it still doesn't route.
FYI, I changed the Interface to also be Inside just in case and it did not change any of the final results.
Thank you in advance for your assistance!!!!!