cannot access server after chaning its gateway to the ACE BLade

Unanswered Question
Aug 17th, 2007

Hello,

When I change my server's default gateway from my router to the ACE Blade, I can no longer acess the server except for on the same lan. I create a route map on the router hoping this would help. but it did not. Here is my route-map info:

access-list 120 permit tcp 10.4.7.6 0.0.0.0 eq telnet 64.78.154.58 0.0.0.0

access-list 120 permit tcp 10.4.7.6 0.0.0.0 eq 8082 64.78.154.58 0.0.0.0

route-map cacheservers permit

match ip address 120

set ip next-hop 64.78.154.7

apply to vlan 11

int vlan 11

ip policy route-map cacheservers

My guess is a symmetric routing.... but How do I resolve this? I know nating will work, but I can't nat do to some requiments to see the real IP's.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Mad__Prof Sat, 08/18/2007 - 20:33

Do you have a route to the gateway on the ACE ?

If possible post a sanitized configuration.

Thanks

KS

Gilles Dufour Mon, 08/20/2007 - 02:16

is the traffic asymetric ?

like the client going through the router and the server responding through ACE ?

ACE does not like asymtric traffic. So make sure all traffic goes through ACE.

Gilles.

Actions

This Discussion