Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
340
Views
0
Helpful
1
Replies

FXS and FXO ports not showing

marc.lehner
Level 1
Level 1

‎08-18-2007 02:13 PM - edited ‎03-14-2019 11:08 PM

Hey all. I hope this is a simple one:

A 2801 shows this inventory:

Installed image archive

Cisco 2801 (revision 6.0) with 179200K/17408K bytes of memory.

Processor board ID FHK1044F2QH

2 FastEthernet interfaces

1 ATM interface

1 Virtual Private Network (VPN) Module

1 DSP, 8 Voice resources

1 802.11 Radio

IOS: Version 12.4(15)T1, ADVENTERPRISEK9-M

The 2 new installed cards: 2fxs and 2fxo in slot 0 and 2 are not being recognized.

The PVDM is seen as PVDM2-8 successfully.

After trying a few IOSs i gave up. Any idea what IOS will recognize the VICs?

Many thanks.

Labels:
0 Helpful
1 Reply 1

marc.lehner
Level 1
Level 1

‎08-18-2007 02:49 PM

Turned out to be Vic-2fxo and Vic-2fxs cards not Vic2-2fxo and Vic2-fxs like requiered.

2800 series requieres VIC2 cards.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents