08-20-2007 12:09 AM
Hi there,
I'm working hard to get the problem solved but I'm at a loss.
I try to set up an alarm for over threshold in the rttMonJitterStatsRTTMax so the command is i.e. "rmon alarm 1 rttMonJitterStatsRTTMax 5 abs r 10 1 f 5 2 owner config"
but I receive an "Alarm creation failure".
I also tried instead of MIB object name the OID (1.3.6.1.4.1.9.9.42.1.3.5.1.9).
1.3.6.1.4.1.9.9.42.1.3.5.1.9.
1.3.6.1.4.1.9.9.42.1.3.5.1.9.0
1.3.6.1.4.1.9.9.42.1.3.5.1.9.0.
.1.3.6.1.4.1.9.9.42.1.3.5.1.9
.1.3.6.1.4.1.9.9.42.1.3.5.1.9.0
rttMonJitterStatsEntry.9
etc...
I get either an alarm creation failure or an unknown object message.
neither works...
Anyone can help?
08-20-2007 05:18 AM
You need get the specific index value of rttMonJitterStatsRTTMax like shown in the example:
rttMonJitterStatsRTTMax.100.120518706
Can you walk the object to see what the specific value is? Then you can use this.
08-20-2007 06:18 AM
Not really. I only know the snmpwalk method in CLI. But is there any other way I can get the value? Especially if you have console access?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: