Installing 2 WICs on a 3800

Unanswered Question
Aug 20th, 2007
User Badges:

I'm installing 2 T1 WICs w/ 2 ports each. I'm going to use 3 of the ports each with it's own T1 card. At the same time I'm going to drop the existing serial DS3 module in favor of these T1 WICs. So if this is the config. of the serial:

interface Serial1/0

ip address 160.x.x.x 255.255.255.252

ip access-group 101 in

ip verify unicast reverse-path

no ip redirects

no ip unreachables

no ip proxy-arp

ip route-cache flow

dsu bandwidth 44210

scramble

no cdp enable

how do i go about getting the 3 WICs configured to use this IP and ACL. Do I need to bridge them? If so how?

Here is what's showing on the WICs now.

controller T1 0/0/0

framing esf

linecode b8zs

!

controller T1 0/0/1

framing esf

linecode b8zs

!

controller T1 0/1/0

framing esf

linecode b8zs

!

controller T1 0/1/1

framing esf

linecode b8zs

Again I am only using 3 of the interfaces.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Mon, 08/20/2007 - 13:29
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

If you control the router on the other side, you can configure multink PPP with the multlink interface.

spremkumar Mon, 08/20/2007 - 19:23
User Badges:
  • Red, 2250 points or more

hi


As Paul mentioned if these links are terminating on the same router in the remote location then u can make a logical bundle and forward the traffic via the bundle.


But if its terminating on different devices then better to have induvidual links configured to carry the traffic.


regds


Actions

This Discussion