Monitoring ME 3400 QoS.

Unanswered Question
Aug 20th, 2007

2 questions:

We have a ME 3400 con qos configured, we'd like to monitor the bw per class, we have two ways, one using the "show policy-map interface output/input" however the output is not showing the bps rate:

Switch#show policy-map interface output

FastEthernet0/1

Service-policy output: OUT

Class-map: VO (match-any)

0 packets

Match: qos-group 1

Priority

police cir 2000000 bc 62500

conform-action transmit

exceed-action drop

conform: 0 (packets) exceed: 0 (packets)

Output Queue:

Max queue-limit default threshold: 16

Tail Packets Drop: 0

Class-map: DCO (match-any)

1414 packets

Match: qos-group 2

Traffic Shaping

Average Rate Traffic Shaping

CIR 5000000 (bps)

Output Queue:

Max queue-limit default threshold: 48

Tail Packets Drop: 0

Class-map: class-default (match-any)

3830 packets

Match: any

Output Queue:

Max queue-limit default threshold: 48

Tail Packets Drop: 0

Bandwidth 3000 (kbps)

Output Queue:

Max queue-limit default threshold: 48

Tail Packets Drop: 0

1. Is there a way to see the bps rate per class?

2. Using SNMP did not work also. Any help???

Thanks and regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
swaroop.potdar Thu, 08/23/2007 - 10:13

12.2(35)SE, 12.2(25)SEG1 & SEG , 12.2(25)EX1 & EX These release for the ME3400 support Class-Based-QOS-MIB

HTH-Cheers,

Swaroop

swaroop.potdar Fri, 08/24/2007 - 06:03

Mario, I agree to what you have mentioned,but I believe the above list should be reliable, do give it a try and check.

HTH-Cheers,

Swaroop

swaroop.potdar Fri, 08/24/2007 - 06:34

Can you try the CLI command as follows,

show policy-map interface [ specify interface id here or leave it] output/input.

for Eg:

show policy-map interface fa0/1 output.

HTH-Cheers,

Swaroop

Actions

This Discussion