Cisco 2850 to Checkpoint R55

Unanswered Question
Aug 21st, 2007

I currently have a cisco to cisco vpn on my external interface, I would like to now configure a cisco to checkpoint vpn on the same interface. Can anyone point me in the right direction for configuration help? Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
miclulich Tue, 08/21/2007 - 12:41

Depending on the type of Cisco and Check Point device you have there are a couple of documents that you might want to take a look at.

The first involves configuring an IPSec Tunnel Between a Cisco Router and a Checkpoint NG.

http://www.cisco.com/warp/public/707/ipsec-checkpt.html

If you have a Pix you might want to take a look at this document.

http://www.cisco.com/warp/public/110/cp-p.html

The important thing to note is you need match up the phase one (ISAKMP) and phase two (IPSEC) parameters on both ends.

Good luck!

Actions

This Discussion