MGCP Gateway with T1-CAS for IPCC Express

Unanswered Question

Does anybody know if this can be done? I am being told that in order to use T1-CAS trunks and have Caller ID show on the phones is to use an H.323 gateway.

Is it possible to configure my 3845 as a MGCP gateway and still provide caller id to my Call Center folks?

Any help would be appreciated.

Thank you,

Ben

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
a.gooding Mon, 08/27/2007 - 20:54

See this thread for a detailed response

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddf3f07/0#selected_message

Also, in some areas T1-CAS doesnt support Caller ID at all (i.e My area - Caribbean. we dont have the FG that supports CLID) we therefore have no choice but to go with ISDN-PRI.

i also think that there are some limitations with MGCP vs H323 (i COULD BE WRONG) with respect to blocking calls, where MGCP does not support it but H323 does.

Actions

This Discussion