CM6 - Secondary server not an ?Available Cisco Unified Comm server"

Unanswered Question
Aug 21st, 2007

I?m setting up a new cluster of servers running Cisco Unified Communications 6.0.1.1000-37. I setup a primary node without any problems. I followed the installation guide and setup the secondary server under ?System-Servers? before I actually installed Unified Communications on my secondary server. The install went great, but once it?s up, I don?t see my secondary server listed in the ?Available Cisco Unified Communications Managers? box under System-Cisco Unified CM Group. I see the same thing when I try and setup a CM group from my secondary server. Only the primary is listed. When I configure a test phone, the data is replicated to the secondary just fine. When I go to ?Cisco Unified Operating System Administration? and look under Show-Cluster, it displays both servers and the ?Type of Node? is correct. Any ideas how I can make my secondary server an ?Available Cisco Unified Communications Manager??

Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
kevinparker Thu, 01/24/2008 - 11:33

Did you ever end up finding the resolution to this? I am having the exact same issue.

Thanks

jgentsch Thu, 01/24/2008 - 12:54

Kevin,

Shouldn't you be able to figure this out on your own?

Jude

Actions

This Discussion