LS1010 - Changing ISP

Unanswered Question
Aug 21st, 2007
User Badges:

Hi All,


I am definitely over my head with LS1010.


Here is the situation and I am not at all familiar at all with the LS1010.


I have DS3 ATM circuit with Verizon and Verizon also was a ISP for my school. I am changing the ISP to another company and Verizon has mapped PVC from my school to the new ISP company. However, I have no idea how to change the information on the LS1010. I was told to change the following settings:


VCC

VCI

VPI


Can anyone help!!! I am supposed to do this on Friday!!!


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
graemeporter Wed, 08/22/2007 - 03:42
User Badges:
  • Bronze, 100 points or more

Hi there,


I've never even seen these before. However, after a bit of digging on Cisco's website, I found this link which may help you:


http://www.cisco.com/en/US/products/hw/switches/ps1893/products_configuration_guide_book09186a00800f4ef4.html


Hope it's of use!


EDIT: Picking at this document further at least shows that the LightStream 1010 runs some version of IOS, so configuration shouldn't be too difficult.


Have you ever used a Cisco device previously? If so, can you access the device and do "show run" and paste the configuration here?


Kind regards,

Graeme

cyberslee Wed, 08/22/2007 - 05:50
User Badges:

Thanks for the reply!


The link seems very helpful. Unfortunately with limited experience with Cisco product, it will be a challenge to understand the document and how to configure it.


Once again, thanks!

Actions

This Discussion