In our lab we have a 3600 with a bank of mica modems and 2 * PRIs. We want all calls to PRI#1 to go to Group-Async1 and all calls to PRI#2 to go to Group-Async2. Is this possible and how can it be achieved? We are running 12.3 but code upgrades aren?t an issue.
The dialer pool / dialer pool-member doesn't seem to be an option. Incoming calls terminate on line 33 and then rotate in sequence to line 44 and back to 33.
Our basic config is;
!
controller E1 0/0
pri-group timeslots 1-8,16
!
controller E1 0/1
pri-group timeslots 1-8,16
!
interface Serial0/0:15 <<-- We want this to terminate on group-async 1
no ip address
isdn switch-type primary-net5
isdn incoming-voice modem
!
interface Serial0/1:15 <<-- We want this to terminate on group-async 2
no ip address
isdn switch-type primary-net5
isdn incoming-voice modem
!
interface Group-Async1
no ip address
dialer in-band
async mode dedicated
group-range 33 38
!
interface Group-Async2
no ip address
dialer in-band
async mode interactive
group-range 39 44
!
line 33 44
login local
modem InOut
transport input all
!
Any ideas?
Philip.