Unanswered Question

I am trying to add this command to a 2811 router (interface ATM1/0

description 26HCGJXXXXXX

no ip address

ip nbar protocol-discovery

no atm ilmi-keepalive

no scrambling-payload

interface ATM1/0.36 point-to-point

bandwidth 1382

ip address

ip nbar protocol-discovery

pvc 1/36

vbr-rt 1382 1382 1

tx-ring-limit 3

service-policy output Voice)

but get a "% Invalid input detcted a ^ marker error message. I inserted the command

"controller t1 0/0/0

mode ATM AIM 0

framing ESF

linecode b8zs" but still displays error. Is there another command I need to add so that it see ATM? Any suggestions would be greatly appreciated.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion