how do I add ATM command?

Unanswered Question

I need help trying to add this command to a 2811. Can someone tell me what the command is to add it to startup-config?


interface ATM1/0


description 26HCGJxxxxxx


no ip address


ip nbar protocol-discovery


no atm ilmi-keepalive


no scrambling-payload


!


interface ATM1/0.36 point-to-point


description DATA traffic to xxxx Street


bandwidth 1382


ip address 10.xxx.xxx.xxx 255.255.255.252


ip nbar protocol-


pvc 1/36


vbr-rt 1382 1382 1


tx-ring-limit 3


service-policy output Voice


!


!


interface ATM1/1


no ip address


shutdown


no atm ilmi-keepalive


no scrambling-payload


!


interface ATM1/2


no ip address


shutdown


no atm ilmi-keepalive


no scrambling-payload


!


interface ATM1/3


no ip address


shutdown


no atm ilmi-keepalive


no scrambling-payload


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
royalblues Wed, 08/22/2007 - 14:05
User Badges:
  • Green, 3000 points or more

Friend,


whatever you configure goes into the running configuration.

To have the same copied to your start-up config just do

wr mem or

copy run start


you can view what is there in the start-up config by issuing the command

sh start-up config


HTH

Narayan



Actions

This Discussion