08-22-2007 03:55 PM
hello all
Im in the process of upgrading the nam module to a new version of software and the image I was trying to go to is c6svc-nam.3-6-1a.bin.gz. The FTP process finished then when the install started the below error comes. I have researched for hours but nothing I tried has worked. Short of calling tac... any possible solutions? thanks in advance
Image verification failed.
The image you are trying to upgrade is not a valid
Maintenance image or is not compatible with this release.
Upgrade with <ftp://root@192.168.0.1/c6svc-nam.3-6-1a.bin.gz> failed (1)
root@localhost.test.com# sho ver
NAM application image version: 3.3(1)
Maintenance image version: 2.1(3)
NAM Daughter Card Micro code version: 1.31.1.27 (NAM)
BIOS Version: 4.0-Rel 6.0.9
Installed patches:
08-22-2007 05:24 PM
You need to reboot the NAM into maintenance mode before you upgrade its main image. See http://www.cisco.com/en/US/products/sw/cscowork/ps5401/products_installation_and_configuration_guide_chapter09186a00807ed582.html for instructions on upgrading the NAM.
08-22-2007 09:47 PM
Thanks Joe
I will follow your instruction.
Will follow up in the post on results.
Thanks again
Jeff
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: