netflow on port-channel interface not work

Unanswered Question
Aug 22nd, 2007
User Badges:

I have a layer 3 switch, gi1/1 & gi2/1 is port-channel and the channel port is a routed port. I have configured "ip flow ingress" for interface port-channel1, gi1/1 & gi2/1. But it seems that the netflow doesn't work. Below is the inteface config. Is there any config mistake.



int port-channel1

ip address x.x.x.x x.x.x.x

ip flow ingress


int g1/1

channel-group 1 mode on

ip flow ingress


int g2/1

channel-group 1 mode on

ip flow ingress


Thanks.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
wbreitzke Tue, 08/28/2007 - 14:09
User Badges:

Follwoing commands used to configure Netflow for the CatOS.

set mls flow , set mls nde 9996, set mls nde version

set mls nde enable.


avmabe Tue, 08/28/2007 - 19:25
User Badges:
  • Bronze, 100 points or more

what kind of cisco switch/router is this???


That makes a difference.

Actions

This Discussion