08-22-2007 06:33 PM - edited 03-05-2019 06:03 PM
I have a layer 3 switch, gi1/1 & gi2/1 is port-channel and the channel port is a routed port. I have configured "ip flow ingress" for interface port-channel1, gi1/1 & gi2/1. But it seems that the netflow doesn't work. Below is the inteface config. Is there any config mistake.
int port-channel1
ip address x.x.x.x x.x.x.x
ip flow ingress
int g1/1
channel-group 1 mode on
ip flow ingress
int g2/1
channel-group 1 mode on
ip flow ingress
Thanks.
08-28-2007 02:09 PM
Follwoing commands used to configure Netflow for the CatOS.
set mls flow
set mls nde enable.
08-28-2007 07:25 PM
what kind of cisco switch/router is this???
That makes a difference.
08-30-2007 07:45 PM
i am using catalyst 6509 with native ios.
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: