cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1171
Views
4
Helpful
2
Replies

Cisco Catalyst 500 and NTP

serotonin888
Level 1
Level 1

Hi All,

Does anyone know how to change\add a ntp server into the config on a catalyst 500 express switch?

It seems to be going to an internet NTP server by default.

Many Thanks

Andy

2 Replies 2

Hi,

From: http://www.cisco.com/application/pdf/en/us/guest/products/ps6545/c2001/ccmigration_09186a0080539179.pdf

The switch clock is automatically synchronized with the

system clock on your network management station. You can manually set the

system clock settings if the switch should have different time settings.

I hope this helps.

Best regards.

Massimiliano.

purohit_810
Level 5
Level 5

Task Command

Step 1

Specify the IP address of the NTP server.

set ntp server ip_addr

Step 2

Enable NTP client mode.

set ntp client enable

Step 3

Verify the NTP configuration.

show ntp [noalias]

Regards,

Dharmesh Purohit

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: